OPTIMIZATION OF CUTTING FORCE DURING LATHE PROCESSING STEEL 40X

Saruulbold S.; Oyunbat G.

doi:10.31435/rsglobal_ws/30032024/8115

OPTIMIZATION OF CUTTING FORCE DURING LATHE PROCESSING STEEL 40X

Authors

Saruulbold S. School of Technology in Darkhan-Uul, MUST, Mongolia
Oyunbat G. Ph.D, School of Technology in Darkhan-Uul, MUST, Mongolia

DOI:

https://doi.org/10.31435/rsglobal_ws/30032024/8115

Keywords:

Simulation, Mode, Rendering, Depth

Abstract

One of the important parameters of the turning metal is the cutting force. This force is the force that occurs during the cutting process and is influenced by various factors, such as tool wear, temperature in the target zone, and surface cleanliness. Cutting force has a significant influence on the cutting process. This paper presents a correlation between cutting force and turning procedure as a result of comparing experimental cutting force to the Advant Edge program’s result. Determining the main parameters of turning procudere by the Minitab program were the turning speed V=157 m/min, feed s=0.12 mm/rev, depth t=1 mm, cutting force Рz= 2.02 kN, Py=0.74 kN, and Px=1.77 kN.

References

https://studme.org/274290/tehnika/eksperimentalnye_metody_opredeleniya_temperatury_rezaniya_tocheni.

https://arch.kyrlibnet.kg/uploads/KSTUNEJENKO2012-27.pdf.

https://thirdwavesys.com/machining-modeling/advantedge/.

https://iopscience.iop.org/article/10.1088/1757-899X/225/1/012186/pdf.

https://lib-bkm.ru/13370.

Downloads

Published

2024-03-28

Issue

No. 1(83) (2024): World Science

Section

Engineering Sciences

License

All articles are published in open-access and licensed under a Creative Commons Attribution 4.0 International License (CC BY 4.0). Hence, authors retain copyright to the content of the articles.
CC BY 4.0 License allows content to be copied, adapted, displayed, distributed, re-published or otherwise re-used for any purpose including for adaptation and commercial use provided the content is attributed.